Henk Vandenbergh

'end_cmd=' parameter executed too often

There are two sets of 'start_cmd=' and 'end_cmd=' parameters. One set is used as a 'general' parameter, allowing these commands to be executed at the start and at the end of an execution. The other set is a sub parameter of a Run Definition (RD), allowing these commands to be executed at the start and at the end of each run (RD). Francois just notified me that the former 'end_cmd=' command is not executed at the end of a Vdbench execution, but instead at the end of each RD.

To fix this, place 'endcmd.tar' in your Vdbench install directory, untar (tar -xvf endcmd.tar) and you now should have a new directory and file: vdbench/classes/Vdb/Reporter.class.

Henk.

Posted at 09:03AM Oct 21, 2009 by Henk Vandenbergh in Sun  |  Comments[0]